Car Questions

No power after repl...
 
Notifications
Clear all

No power after replacing parts

  

0
Topic starter

2015 ford f-250 sd xlt 6.2 flex fuel new coils and 16 plugs new mass air sensor and filter new battery.

I bought this truck from an auction, it was running rough, was told it needed tune up with points and plugs. I did that even cleaned the fuel throttle body as it was all gummed up. Before I did that though the truck started being more difficult to start, the dash lights would flash and I would get a long start when cranking it. After doing all the tune up I get no power to the ignition no lights or even door chime, any ideas?


6 Answers
1

Stay away from auction cars.

Try shooting some starting fluid into it.


1
Posted by: @onebigoldbird

Where would one look for and find a wiring diagram for a 2015 ford F-250 SD with the 6.2 V8 flex fuel.

Although charm.li provides a lot of free service information, they only go up to 2013 for your truck.

If you cannot find a free wiring diagram online you could elect to sign up for an inexpensive short-term subscription to ALLDATAdiy. That will give you access to all service information for your vehicle for a month.

Alternatively you may be able to have an Autozone store print out a wiring diagram for you at no charge. (AutoZone owns Alldata.)


0

Please note for future reference that the title line is intended for a short description, not the full description of your vehicle problem. Thank you. (Title edited.)


Is that your answer?


it's a reminder about how to use our forum


0
Posted by: @onebigoldbird

I bought this truck from an auction, it was running rough,

Big mistake. Buying from an auction is a real crapshoot with high probability of bad results.

Posted by: @onebigoldbird

was told it needed tune up with points and plugs.

Who told you that? Whoever it was didn't know what they were talking about or were just flat-out lying. Kettering ignition (points) has not been in use for nearly 50 years.

Posted by: @onebigoldbird

After doing all the tune up I get no power to the ignition no lights or even door chime, any ideas?

Assuming the battery and cables are OK you're going to have to trace out the electrical fault using a wiring diagram. It's possible a master fuse or fusible link has blown.

 


0
Topic starter

Coils and sparkplugs, 16 of then, new mass air sensor, it was running starting when I got It. But now there Is no power to start with


0
Topic starter

Where would one look for and find a wiring diagram for a 2015 ford F-250 SD with the 6.2 V8 flex fuel. I've looked through the online manual as one did not come with the truck. Would Ford provide this item?


Share: