Notifications
Clear all
0
22/06/2021 10:04 pm
Topic starter
Ive have read this issue is common on higher mileage Honda vehicles equipped with Vtec.
I have had my Vtec solenoid and all other appropriate components in the module replace twice now.
The issue as mentioned at the heading of my question is an oil pressure code specific to the Vtec solenoid that causes the car to go into a protective limp mode.
Is there a way to close or loop the signal at the engine’s computer to eliminate this code?
Clarification: What is the mileage and the exact code (per your scanner)?
I procrastinate. If I can I will do OBD test again and reciprocate that info.
Thanx for your help!
1 Answer
0
23/06/2021 6:38 am
I suppose some computer geek could figure out how to reprogram it but there's no easy bypass
Thank you for your input and helpful site!