Notifications
Clear all
0
14/11/2021 1:50 am
Topic starter
Hi Scotty, i have a 2001 Toyota 4runner 4x4 with 250000 mileson it. I replaced the lower balljoint left side. The stud on the balljoint keeps spinning when i try to tighten castle nut on the balljoint? I tried putting pressye on it under a arm no go. My next alternative is to put the tire on lower 4runner on its wheels putting pressure that way on the balljoint. Any suggestions. Thank you Scotty and thank you so much for your knowledge passing it on to us. Its really appreciated Sir.
1 Answer
0
14/11/2021 6:47 am
Well what I do is I put a jack under the lower control arm and then a piece of two-by-four and I jack it up to try to get pressure on it so it'll be tight or so it was kawana not spin you might also put a little lube on them bolt itself to help it go on better
