I have a 1990 Chrysler Le Baron 3.0L 6cyl. I replaced the oil pan gasket, reinstalled it as I attempted to reinstall the starter and the front lower engine mount I not able to line up the bolt holes on the engine mount bracket which also has a extented arm on the bracket that has to reach back to a bolt that attaches that bracket to the bottom section of the transmission below the flywheel. The engine is sitting too far back to line up. I loosened the top right engine mount bolts to give some play on the block but isnt moving forward enough. There about 1inch and 1/4 gap. What should I do?
Ice phone when you mess around with that crap me I use two separate jacks that can be moved back and forth and when the bolts don't line up I get a long pry bar that has a sharp end and try to stick it through the holes to get into line up and then try to slip the bolt in fast
