Hi Scotty!
I drive a 2002 Jeep Wrangler X with the inline 6 cylinder with automatic transmission.
I recently was unable to engage four low while out on the trail. So I had a Transfer Case Shift Cable Conversion Kit installed.
While installing the conversion kit we needed to replace the transmission mount as it crumbled when we took it off for the install.
The Jeep shifts fine now, but when I come to a stop at a red light the Jeep shakes badly
I went ahead and installed new engine mounts thinking it would help eliminate the vibration while at a red light, but it still shakes. Can you help? Any suggestions?
PS- I have no trouble codes showing.
Thanks in advance!
Keep up the good work!
I went ahead and installed new engine mounts thinking it would help eliminate the vibration while at a red light, but it still shakes.
What kind of engine and transmission mounts did you install?
PS- I have no trouble codes showing.
There are no codes for engine mounts.
