I recently replaced the struts (Monroe Quick Struts) all around with new inner and outer Moog tie rod ends, AC Delco sway bar end links, rear sway bar bushings and new rotors and pads (Bosche). I am still getting intermittent squeaks and creaks when turning and going over bumps. I took Scotty's advice and spray the remaining bushings and rubber components with AT-205 that I did not feel like or needed replacing.
Other than possibly needing one or two new front wheel bearings I am unsure what else I could do. Any ideas why I would still be getting creaks over bumps and turns? I also put polyurethane hangers on the exhaust.
I would look at the all the suspension bushings and motor/tranny mounts.
If you used polyurethane bushings did you apply the silicone grease to them? The grease will prevent the squeaking sounds.
