ANYONE HAVE EVER PREFORMED A REAR WHEEL BEARING REPLACEMENT? I am trying to replace it the easiest way without to taking the CV AXLE off. The hub and the bearing doesnt go as one unit, its just a hub with the studs and wheel bearing in the housing with the snap ring holding it. I read manual, it says to take the parking brake, then removing mounting bolts off then jumps to pressing old bearing out. I have never done this in this kind of set up. Any suggestions would be appreciated.
You pretty much have to take the CV axle offer you'll never get it apart or if you do ram it apart you'll never get it back together again.
What would be the best approach to take it off without taking everything apart? Manual says to disconnect the shaft to the read diff and lower the rear diff to have enough room. But i was thinking of putting the jack on the part where the shocks sits and remove the bolt that holds it together and pray it has enough room to move it and be able to pull it out.