Notifications
Clear all
0
22/12/2020 11:55 am
Topic starter
2005 Honda odyssey. After taking the crankshaft pulley off, how do I make sure that is tightened appropriately when reinstalled? I have not tried to take it off yet, but I will use a breaker bar and 19 mm bolt and bump the engine. My impact is 300 foot pounds. How do I make sure that I reinstall the new crankshaft pulley to the correct torque? Thank you.
1 Answer
1
22/12/2020 8:01 pm
I realize the rub I use an impact wrench if you don't have an impact wrench then the only way you could possibly do it was get a strap wrench that fits around the crank pulley you tighten it there and then when you hold that still you get a torque wrench and tighten the nut on so it doesn't spin
