Hi I watch your video on crank no start on my fusion and I did the spark plug test and no spark from the wirer to the plug van you help me futher
See if a scan tool give you an RPM reading while cranking. If not your crank sensor is probably bad.
I did a volt meter check on the crank senser it said it was at the right restance. I don't have a scanner.i tried to get the codes by turning off on 3 times didn't work neither did holding in the milage reset button.
I got a scanner and it had no codes on it and displayed no codes
I don't have a scanner.
You need one to do any meaningful diagnostics on a modern OBD2 vehicle.
i tried to get the codes by turning off on 3 times didn't work
The blink codes generated by doing that kind of thing are primarily for OBD1 (pre-1996) vehicles.
I hook up a scanner got no codes .it cranks its just not kicking in the firer part of the start I check the fuzes switch them around even still nothing
What about seeing an RPM signal in the data?
I don't belive so a guy from a garage came and did it for me and said it had no codes and nothing displayed
Have you checked your fuses?
no spark from the wirer to the plug
no spark on any plug?
https://www.youtube.com/watch?v=XcmWa2Bt12U
