2013 Nissan Altima - Getting a code for the brake stop switch. I replaced the switch but the car still goes into "limp" mode. I have to shut off the engine then restart it. It then runs good. Any suggestions? Thanks.
What was the code? (Codes don't usually refer to a specific part being bad, but to a condition that may have several potential causes.)
po448
P0448 is an evap system code. Here is the diagnostic procedure for that code from the factory service manual:
Also, are you having some kind of network problem? Your response was posted over a dozen times! (The screen shot below is just a small sample.) Please be careful about multiple posts. In most cases you will find that even if the site appears to be unresponsive when you hit the red button your post has been immediately processed. Thank you.
@chucktobias Sorry Chuck, the code for this problem is C1116-00
Sorry Chuck, the code is C1116-00
@sugardel1 You are posting multiple responses again, 8 times so far for this one. Please stop!
@sugardel1 Your multiple responses are still coming in, I'm starting to lose count but I think it's about 15 so far. I'm going to have to lock this thread for a short period of time to stop them.
@sugardel1 OK, I've opened this up again, hopefully that was enough to stop the flood of duplicates. If you have an unstable internet connection please wait until you have a better connection before posting. See my previous response that has a link to the diagnostic procedure for C1116.
po448