I recently replaced both my inner and outer tie rod ends on my vehicle. 2011 Toyota Sienna XLE. After doing so, the "check VSC system" appeared on my info screen. I tried disconnecting the battery to reset ECU, still there. Disconnected battery again, and took out VSC fuse #6 underneath the driver side panel, still there. I even turned on the light to dissipate any left over power, still there. No check engine light showing. Plugged in OBD2 scanner and it says no fault showing. I reinspected my work underneath the vehicle and I'm not seeing anything wrong that I could have done. Changing tie rods, inner and outer, is not that difficult. If there is anything else that I can do besides going to a dealership will be much appreciated. Looking forward to any suggestions. Please help!!!
Get the two in alignment shop because of the alignment is off the vehicle speed control cannot work right and pray that you didn't damage any of the sensors doing that work or the wiring going to the sensors which will make the VSC system trip codes
@scottykilmer
I appreciate the prompt response. I forgotten to mention that I did get an alignment done immediately after I was done with the tie rod change and was hoping that the system would fix itself. Of course it's been a few days now and many miles of driving, the message still shows. Should I take it to a different shop and explain to them what you told me and have them look into it?