Hello,
It is a Volvo S80 2002 2.9i 2922ccm B6294S2 engine code.
6 cylinders
When engine cold, cylinder 2 not works. I have to drive the car for 15-30 minutes. Then stop the car. Then restart the car. After then it works. But sometimes it loose the operation.
Vida code when engine cold:
ECM-2320 Injector cyl 2 - signal missing
I sprayed the connectors with WD-40 contact spray. But still the same. Injector works only when hot. Repairman told maybe injector is worn.
I need to drive the car at Christmas. 1 hour drive to address, stay there, then some hours later 1 hour drive back.
Now the car turns off cylinder 2, but works. Can I use it for that 1-1 hour drive?
Well pray you need to do the wiring harness to that injector over. Because of it's not that it would mean that the driver circuit in the computer is going bad and they cost a ton
Well pray you need to do the wiring harness to that injector over. Because of it's not that it would mean that the driver circuit in the computer is going bad and they cost a ton
We are pretty sure about it. Because the repairman used a multimeter device to test it when injector connection was unplugged. We compared the multimeter values with the other injectors and the cylinder 2 shown a bad value.
I need to use the car on xmas, Can I use it for that 1-1 hour drive?
I need to use the car on xmas, Can I use it for that 1-1 hour drive?
Up to you. It's very risky to take a malfunctioning decades-old car on a long trip. Do you have a towing service to call if it dies on the road?
Scotty says it can be bad injector, wiring or shot computer at 3:12
https://youtu.be/CSjIVfldAwY?si=s2zBrBLT--XhdcND
Scotty says check wiring connector, otherwise it can be bad injector, wiring or shot computer at 3:12
https://youtu.be/CSjIVfldAwY?si=s2zBrBLT--XhdcND