Notifications
Clear all
0
04/06/2022 11:58 pm
Topic starter
i have a 2007 Nissan Murano. Im replacing one of the wheel studs on the front wheel. I read you can draw it through with washers and a lug nut. The issue is that once it gets so tight the sryd just starts turning while I tighten it and it wont draw through. Any ideas on what i can do to draw it in. I just have hand tools no electric tools. Thank you!
1 Answer
3
05/06/2022 12:07 am
You need to stop the stud from turning.
- Add two more (plain, flat) nuts to the tip of the stud (the end facing you ), and then jam them together such that the faces align.
- Then put a breaker bar, big wrench, or something on the jam nuts to keep the stud from turning.
- Tighten your 1st nut the way you've been doing.
Hey, I'm stuck in the same situation as Taylor, I did as you said and it keeps on spinning, do you recommend to take the hub off and use a press?
A press will work too
Share: