Notifications
Clear all
0
16/10/2024 6:10 pm
Topic starter
So in my 61 c10, I cannot get it into gear. I have replaced the master cylinder, slave cylinder, throughout bearing, adjusted the pedal, adjusted the slave cylinder push rod, and still no clutch. My only guess is the clutch disc but it looked fine when I had the transmission out. I need some help I have no idea what to do now.
1 Answer
0
17/10/2024 5:17 am
Well if there's air in the system you won't have any clutch. What you should do is see if the clutch slave is pushing in and out at the transmission. Have someone step on the clutch pedal and you be under the truck and see if it's moving in and out. If it isn't, there's air in the system or the master or a slave is bad. If there is motion full back and forth in the clutches worn out inside the vehicle
