We have a 2007 Honda Civic, 250,000 miles, automatic.
We were driving when the car dropped in speed shut off. Got it into a parking lot
and tried to start it, it started but would not move, it was shaking and not moving
much.
Managed to get it to an AutoZone in the complex he was in, moving very slow, the
machine gave these codes..P0102...P0113...P0420....P0407.
Since then all the following have been replaced So far we have changed all the sensors, sparkplugs, catalytic converter, egr valve,
cleaned injectors, cleaned throttle body and intake, checked all fuses, tested for a
short in battery, cleaned fuel system, changed 02 sensors.
There are no codes left. Also changed the fuel pump.
The car starts a little better, getting more gas, and still runs for a few seconds
stalls. What are we missing???
Has anyone tested the ignition switch?
No I don't think so, this never came up. How do you test that? Thanks.
Grab a multimeter
.
Disconnect the 7 pin connector (A) from the ignition switch (B)
.
.
Check for continuity between the terminals in each switch position according to the table
.
.
Make sure you "jiggle" the ignition key a little when checking the "ON" position terminals.
Ok, gonna try this tomorrow. Thank you
Ok, that is not the issue. Car starts and runs rough then shuts off. We have dash lights of oil, battery, key and engine. All fluids have been checked and are good.