I'm using a BlueDriver scan tool and I have a few scan results in the Mode 6 area that shows several items that say "Test not complete". There are no codes tripped. I'm not sure if I should care about these or if I have some kind of problem. Here are the ones that give me that message:
Oxygen Sensor Monitor Bank 2 - Sensor 1 (I have 2 of these listed - 1 shows passed, the other test not complete)
Catalyst Monitor Bank 1 (I have 2 of these listed - 1 shows passed, the other test not complete)
Catalyst Monitor Bank 2 (I have 2 of these listed - 1 shows passed, the other test not complete)
EVAP Monitor (0.020”) (I have 3 of these listed - 2 shows passed, the other test not complete)
Fuel System Monitor Bank 1 (I have 2 of these listed - 1 shows passed, the other test not complete)
Fuel System Monitor Bank 2 (I have 2 of these listed - 1 shows passed, the other test not complete)
Test not complete means the system has not cycled through yet. You need some more driving time.
I'm not so sure that that the BlueDriver is going to give me enough info. I just ran a mode6 report on the 02 Mustang GT and got a lot less info than I got from the Xterra and it had 4 "Manufacturer defined" tests that tell me nothing. Sometimes the BlueDriver doesn't ID the vehicle year/make/model and VIN and sometimes it does.