I'm replacing the lower control arm bushing and I installed the new one on the passenger side now I'm on the driver side and the main bolt or threaded boat that goes through the bushing is not lined up it's too far over there and I need it to line up so that I can get the bushing on and voted down how can I get the bushing Center moved over is too far to the left or to the right but how can I get it centered so I can get the bushing on?
You left out a few details, requested in the posting instructions, that might be relevant:
A picture might also be helpful.
2016 Chevy Traverse LT
The Chevy repair manuals at charm.li only go to 2013. However, a 2016 model is a facelifted 1st-generation model that debuted in 2013 so the manual should be relevant. Check out the suspension section on lower control arm bushing replacement to see if it is helpful:
https://charm.li/Chevrolet/2013/
2016 Chevy Traverse LT