Thank you guys i think i will try the bluedriver obd scan tool

FYI: As of Nov. 6, BlueDriver support reading/clearing codes from:

- Accessory Gateway
- Adaptive Front Lighting
- Adaptive Front Lighting (Subsystem)
- Automatic High Beam
- BCM
- Back Door
- Blind Spot Monitor Master
- Blind Spot Monitor Slave
- Camera - Forward
- Central Gateway
- Door Motor - Driver
- Door Motor - Passenger
- Door Motor - Rear Left
- Door Motor - Rear Right
- Electric Parking Brake
- Grill Shutter
- Immobilizer/Steering Lock
- Lane Assist
- Master Switch
- Occupant Detection
- Panoramic View Monitor
- Parking Assistance
- Power Roof
- Power Source Control
- Radar - Forward
- Rain & Humidity Sensor
- Remote Starter
- Road Sign Assist
- Seat - Driver
- Smart Key
- TPMS
- Telematics
- Vehicle Proximity Notification System
- 4WD
- A/C
- ABS
- ABS (EPB)
- Adaptive Cruise Control
- Airbag
- Auto Stop/Start
- ECM
- Electric Propulsion Control System
- Instrument Panel
- Motor Generator - Front
- Motor Generator - Rear
- Navigation System
- Parking Assist Camera
- Power Steering
- Pre-Collision 2
- Starting Control
- Steering Angle Sensor
- Transmission
- Immobilizer/Steering Lock

And will display the following live data:

- Fuel System Status
- Calculated Engine Load Value
- Engine Coolant Temperature
- Short Term Fuel % Trim - Bank 1
- Long Term Fuel % Trim - Bank 1
- Engine RPM
- Vehicle Speed
- Timing Advance for Number1 cylinder
- Intake Air Temperature
- Mass Air Flow Rate
- Absolute Throttle Position
- Time Since Engine Start
- Distance Traveled While MIL is Activated
- Commanded evaporative purge
- Fuel Level Input
- Number of Warm-ups Since DTCs Cleared
- Distance Traveled Since DTCs Cleared
- Barometric Pressure
- WRO2 B1S1 (l/mA)
- WRO2 B1S2 (l/mA)
- Catalyst Temperature Bank 1, Sensor 1
- Catalyst Temperature Bank 1, Sensor 2
- Control Module Voltage
- Absolute Load Value
- Commanded Equivalence Ratio
- Relative Throttle Position
- Ambient Air Temperature
- Absolute Throttle Position B
- Accelerator Pedal Position D
- Accelerator Pedal Position E
- Commanded Throttle Actuator
- Engine Run Time While MIL is Activated
- Engine Run Time Since DTCs cleared
- Current Fuel Type
- Absolute Evap System Vapor
- STFT 2nd O2 B1 & B3
- LTFT 2nd O2 B1 & B3
- Engine Oil Temperature
- Actual Engine - Percent Torque
- Engine Reference Torque
- Auxiliary Inputs / Outputs
- Commanded EGR and EGR Error
- Fuel Pressure Control System
- Intake Manifold Absolute Pressure
- Engine Friction - Percent Torque
- ISO/SAE Reserved
- ISO/SAE Reserved
- PIDs Support 0xA1-0xBF

… that’s it.

Source: Technical Support Specialist, Lemur Vehicle Monitors 

Do some reading at https://www.obdadvisor.com Perhaps it will help, …
F.S.

Does it work with a laptop computer?