Notifications
Clear all
0
12/03/2021 12:28 am
Topic starter
So on my previous questions I've had a popping noise from my car after doing coilovers I replaced the CV axle and sway bar in the noise was still there I took a closer listen at the noise and it's from the locking nuts on the coilovers I tighten the left side and the noise went away on that side but when I try to tighten the right side the bolt just spins on the ball joint I can't loosen it or tighten it should I hit it with an impact gun?
1 Answer
0
12/03/2021 7:33 am
I would try and impact gun and if that doesn't work if you're going to replace it you can heat up with a torch and then use an impact gun the torch of course will ruin parts inside but if you're going to replace it you don't care
