Hi, guys, I am having a hard time removing the PCV valve T-Fitting that is connected to a metal pipe, the hose clamps have been loosened and are free to spin, including the T section spins freely but is unable to pop out.
Link To Video: https://youtu.be/D5Holj_Et44
Take note that there is the limited working room because I am trying to do this without removing the intake manifold. Any common methods or tools I could use to remove it.
1. I was thinking of cutting the T straight through (replacement part available) the middle, but I worry that it would leave a part stuck on the right end of the T.
I would cut it if I were you and do it that way because the repair manuals give many hours of Labor to do that job they require removing the intake.
