I bought this car from the auction it has clutch master cylinder issue so I placed an order and got the new one I replaced it but for some reason the starter relay was bypassed with a switch in the car to start the car now after fixing the clutch master cylinder I put a new fuse box unit replaced all the original fuses into the new box including the starter relay but I get no starting to the car no crank nothing no noise whatsoever I checked it started as well there was a loose wire I tightened it but still no cranking. The car will run old fashioned way you have to push the car put it on 2nd gear let go of the clutch the car will go on but as far as starting the car with the key for some strange reason it doesn't work do you have any advice for that. Thank you
My solution was that I bypassed the ignition while you open the car and I put a switch to start the car and stop the car I got direct power from the main wire of the starter relay and I brought it all the way to the switch and I just opened the ignition now and start the car reading through a lot of forms it says that this car is usually have electronic wiring issues between the engine and the fire wall where the wiring is so I'm not going to dig through it too much but it works now
It might have some computer issue that the previous owner bypassed the starter relay. Check the relay and see if it works. If it worked, then find out if you have power at the starter.
